PTFE Non Stick Seamless Fusion Belt
Fusion belt without seam called seamless fusing belt is special belt used for fusing and laminating process without any mark on the garment. The fusion belt is special weaved to be seamless, then impregnated with PTFE resin with shinny surface. Seamless belt overcome the shortcoming that connection of belt with joint is easy to break and the possibility of running deviation. The lifetime of seamless fusing belt will be at least 3times than normal belt with joint.
Advantages
● No marking on the fused textiles
● Smooth surface and nonstick
● Excellent anti-static effect is available if you needed
● Dimension stability
● Wide operating temperature from -70-260°C
● Impervious to all chemical attack
Which machines do seamless belt used on?
Our seamless fusion belt is used in fusing machines like Meyer, Oshima, Hashima, Macpi, Kannegiesser and others.
Standard Sizes of Oshima Fusing Machine Belt
OP-450GS: 460*1530/1840mm
OP-450GSL: 460*1530/2440mm
OP-520GS: 520*1530/1840mm
OP-520GSL: 520*1530/2440mm
The edge of belt is easy to be worn out, Mutiflon can make an edge treatment along side, normally it will be PTFE coated glass cloth or PTFE coated Kevlar, the edge reinforcement is heat pressed by using FEP film for bonding. If customer need to prevent belt running off center, Mutiflon will sew PTFE or Kevlar cord as tracking acid, we use Kevlar thread to sew the guide, thus it is not easy to break under high speed running.